horse sence
15 Year Member
You may need to bolt in the spreader bar under the frame rails to keep the rails the proper distance apart .
IIt was a bit hard to get pics of the measurements so i just wrote them down ,this is a un wrecked 67 coupe .
Starting with D,between the aprons at the hood hinges .
D = 40 inches between aprons
A=7 inches ,this is to the outside of the cowl side panel on all 3 measurements
B= 7 1/8 again to the outside edge
C= 7 1/8 also to the outside edge .
Driver side ,all measurements to the out side edge of the cowl side panel from the inner apron .
E= 7 1/8 out side edge of cowl panel
F = 7 1/8 out side edge of cowl side panel
G = 9 1/4 outside of cowl side panel
H= 9 7/8 out side edge of cowl panel to inner apron .
Hope this helps
Horse sence! You still around? Hope all is well. I took a bit of a break from the project but I’m looking to get back into it. Stopped at the strut rod brackets. Would you be able to send some measurements for installing those?Do you have the front cross brace under the radiator support in yet .I would have that in first .