cams can add very good power throughout the band, i really like my vt stage 2s. Ported heads make them beasts though, so that is also something to consider. Maybe even meaner cams. you are looking at about 30 rwhp or so with the stage 2 cams without a port job. a bit less with the stage ones. what about gears? no hp, but great none the less. maybe the bullitt intake tract if you have the cash, definately some gains to be had there. of course there is the nitrous and supercharged avenue, but im sure you have already thought about that. other than that, porting anything you can would be an option. cant forget a good dyno tune either, you can pick up some ponies there as well.
forget the bullit intake - on an NA setup your best bang for the buck is plenum/TB; and if you were to decide to get an intake manifold get the P-51. Also, look into getting the "Mr. Freeze" kit as described in another thread from Anderson Ford Motorsport.
forget the bullit intake - on an NA setup your best bang for the buck is plenum/TB; and if you were to decide to get an intake manifold get the P-51. Also, look into getting the "Mr. Freeze" kit as described in another thread from Anderson Ford Motorsport.
Agreed. A guy I work with did a build as a side job. It was a 96 GT. He put in a built short block, pi head swap, bullitt intake, and a charge cooled vortech unit. He said he will never install the bullitt intake ever again. After it was all said and done, the cost was actually more than the P51 sheetmetal intake, which he said is a direct bolt on.
There was a nice write up in MMFF a few months ago about the different intakes. They compared stock PI intake v bullitt v p51 and another intake too, dont remember the name though. Anyway, I just remember looking at the results and while the gains for the P51 were good, on an NA car the major gains were only above 5000 rpm. So if any aftermarket intake really worth it if you are NA?