we mounted my buddies in the same spot you did . Ran the harness up over the strut tower like the factory mass air harness used to run . I de pinned the big square plug for the relay box . Passed the harness through the factory grommet. Put the connector back together on the other side and mounted the box on the kick panel .Hi everyone, I'm new to this forum so first off any help will be greatly appreciated and thanks in advance. I've mounted my CPU on the passenger side close to the front after researching many pictures I could find and what I thought would work for my setup. The thing I'm looking for is there anyone out there that has mounted it in the same location and if so can you give me some tips or pictures on where you have ran the wire harness and where you have passed it through the firewall.
Thanks a lot, that's pretty much what I was thinking. One question is there a lot to de pinning the relay box? I haven't really played with them before.we mounted my buddies in the same spot you did . Ran the harness up over the strut tower like the factory mass air harness used to run . I de pinned the big square plug for the relay box . Passed the harness through the factory grommet. Put the connector back together on the other side and mounted the box on the kick panel .
If you have a gen one it was like 6 wires in that big square plug that comes from the ecu that plugs into it . The locks in the connector just slide through . You pull them out . Then you need a small de pinning tool for like a metri pack pin . Fold lock down remove the pins Pass through fire wall . Gently fold pin up and then re insert . Re insert plastic locksThanks a lot, that's pretty much what I was thinking. One question is there a lot to de pinning the relay box? I haven't really played with them before.
we mounted my buddies in the same spot you did . Ran the harness up over the strut tower like the factory mass air harness used to run . I de pinned the big square plug for the relay box . Passed the harness through the factory grommet. Put the connector back together on the other side and mounted the box on the kick panel .
Hey thanks a lot, the de pining went smoothly got it done. Any chance you have pictures of where and how you guys mounted inside the kick panel?
Glad it went well ! I don’t unfortunatleyHey thanks a lot, the de pining went smoothly got it done. Any chance you have pictures of where and how you guys mounted inside the kick panel?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?