90 mm throttle body

Head down to the home store and get a coupler from the sewer pipe section. :D

Seriously, I am pretty sure Daggar has posted a place to get big couplers like that before (if you need to know real quick here). I would look but I gotta get to bed.

Good luck.
 
I used a 4 in. Anderson Power Pipe, the N/A Variety:
AF-0112Cs.jpg

It can be found here: http://www.andersonfordmotorsport.com/pipes/pipes-50.html

If you plan to use a Lightning meter or one that is similar to the Lightning then you'll also need one of these:

prm-80,90adpt.GIF

It can be found here: http://mustang.c-f-m.com/index.asp?PageAction=VIEWPROD&ProdID=1066

Or one of these:

image.php

This one can be found here: http://www.teamjdm.com/shop/product_info.php?products_id=18


For my application, the whole thing would not fit into the fenderwell. I ran out of room where the conical filter came into contact with the braces that support the nose of the car. To fix this probem, I used one of these:
yhst-62818268114394_1864_2480227

It can be found here: http://store.airflo.com/45hl4.html

You will also need to replace the 4 in to 3 in reducer that comes with the Power Pipe with a straight 4 in coupler. I got mine from a ricer shop nearby (why they had 4 inch, I'll never know).

I looked at the site that was listed by someone else in this thread... It's nice stuff. The only trouble that I see is that the largest piece they listed is only 3 inches.

Hope this helps.
 
One last thing...

I bought my conical filter from Anderson as well. Make sure you tell them that you need it in 4 inch or they'll sell you the one that goes with that Power Pipe (3.5 inch).