• General Automotive Forums
  • Other Auto Tech

92 bronco not starting sometimes

  • Thread starter Thread starter fordkid
  • Start date Start date Oct 18, 2008
F

fordkid

New Member
May 28, 2007
69
0
0
Oct 18, 2008
#1
  • Oct 18, 2008
  • #1
Hey guys, I have been dealing with this problem for a while now. at first I was having problems with the charging system, The alternater was bad so I replaced that along with the battery since it was old, it was running fine for a little while but now the bronco won't start after it's been sitting for a while. If I jump start it, it will start right up and run fine. if I drive it for a while and then go into a store or something real quick it usually starts up on it's own but if it sits for a little while then it won't start by it self. Some times when it won't start if you hold the key to the start position it will crank slowly then not crank at all and then all of a sudden start cranking again slowly and builds up speed and then starts. So I am completely lost as to what is wrong with it. While it's running the it says 13.6 Any one have any sugestions on what might be wrong or other areas I should check to at least rule out. Trying to get this truck up and running again before the rain gets here.

Thanks
Ford Kid
 

tx65coupe

Active Member
Nov 29, 1999
1,551
1
37
Oct 19, 2008
#2
  • Oct 19, 2008
  • #2
Try going to ford-trucks.com for help. I have been using that site for years for my 95 F150.

As for you problem, I would say that the starter is on its way out. Especially if it is the original one. It is also possilble that there is a bad connection or ground somewhere. Either that or something is draining the battery.
 
F

fordkid

New Member
May 28, 2007
69
0
0
Oct 20, 2008
#3
  • Oct 20, 2008
  • #3
Thanks, I've been trying to find a good site for ford trucks, The starter is new. I just replaced it not too long ago, maybe 3 months, it was making the famus clicking sound when I tried to start it. So maybe like you said a bad ground somewhere. I will be looking for that as well as posting on the other site.


Thanks
Ford Kid
 
B

buff531

Founding Member
May 11, 2000
1,931
0
36
Hanover Park, IL
Nov 3, 2008
#4
  • Nov 3, 2008
  • #4
i had a similar problem and it ended up to be a bad ground... the negative terminal on my battery was severly corroded... heres what happened with mine though...

i drove it a few times and then the car wouldnt start at all... sometimes, lik eyou said it would crank really slow, sometimes not at all... sometimes it would crank normal but would never start...

i picked up a code scanner tool, pluged it in, cleared the codes, same problems persisted. Pluged the scanner back in... started the car and it started no problems... unplugged the scanner and the car died immediately... tried to start the car with no scanner... it didnt do anything... plugged scanner back in... car started right up... unplugged scanner and it died LOLOLOL

it just ended up to be a corroded battery terminal HAHAHAHA i dont know how, or why it started with the scanner tool, it must of over rode something... anyway you sound like you have similar problems like i had... check / clean those terminals relaly well! or check the connection to the starter as well, along with the ground for the starter... something may of became loose...

:SNSign:
 
F

fordkid

New Member
May 28, 2007
69
0
0
Nov 14, 2008
#5
  • Nov 14, 2008
  • #5
Hey thanks, you guys got me back to the basics. it wasn't a terminal, however it was the battery, even though it was a brand new battery. it was still bad. it would say 13 plus volts when it was running and then when I would shut it off the battery would read 12 pluss volts. so I figured the battery was fine. so for what ever reason I ended up sticking the probs to the volt meter in the terminals so they would stay there with out me holding them so I could watch the voltage as I wiggled wires around the engine bay. I ended up noticing the battery was steadily droping voltage. every minute or so it would drop a tenth of a volt. so I replaced the battery again and now the 2nd new battery has been working for the past few days. Go figure huh. I don't know how many times I am going to have to learn the lesson " just because the part is new doesn't mean it works properly" but hopefully I can remember that this time.


Thanks guys.
Ford Kid
 
You must log in or register to reply here.

Similar threads

9
1997 gt Starts then dies a few seconds after.
  • 97orange
  • Aug 13, 2026
  • SN95 4.6L Mustang Tech
Replies
5
Views
158
SN95 4.6L Mustang Tech Aug 17, 2026
97orange
9
J
can you use the heads off a H O 302 to put on a regular 302 engine
  • Jan H
  • Feb 25, 2026
  • Other Auto Tech
Replies
6
Views
450
Other Auto Tech May 17, 2026
nickyb
Problems after exhaust install and 02 harness
  • djj62478
  • Jul 2, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
39
Views
664
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
B
Engine Another no start after washing engine bay
  • bruno
  • Apr 26, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
826
Fox 5.0 Mustang Tech May 7, 2026
AeroCoupe
A
1987 5.0 speed density Foxbody crank no start
  • Alan2204
  • May 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
407
Fox 5.0 Mustang Tech May 30, 2026
Mcmahst
Share:
Bluesky Email Share Link
  • General Automotive Forums
  • Other Auto Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?