A 67 fast back conversion for Mrs. bbettto !
- Thread starter horse sence
- Start date
I realize this is a bit of an older post, but where do you buy the fastback inner structure pieces? I didn’t know if you bought the kits that come with the rockers and both pillars, or if you found somewhere to buy individual pieces or just the upper components? Any info you can provide would be appreciated.Level and ready to go !i have 8 screw jacks under it ,these house mover jacks are the only way to go!
You can buy the inner structure in un welded form
Anyone that sells Dynacorn parts will have it ,you can't buy just a certain part though it is still a kit only
Yeah, that’s what I’ve been finding. It’s a shame though, because I don’t need the rockers, pillars or wheel housings. I wish someone would offer the parts individually. I imagine if someone could actually locate the Taiwanese factory where they’re actually made, you probably could buy as many of the individual pieces that you wanted.
Do you typically have to slit and reshape the quarters by the rear window panel? I didn’t know if all the 67-68 dynacorn quarters are like this and need correcting to have an even gap around the trunk lid.Passenger side just setting in place and it is just about a perfect fit. But when i get back to the trunk lid to quarter and lower window panel i see the quarter is kind of fish hooked where it meets up to the lower window panel ,this keeps the trunk lid from coming all the way forward so i will have to slice it and push it forward about 3/16 where i have it marked but not quite as much as my mark shows . Shouldnt be a big deal just have to weld up the slice once i get the gap correct.
While trying to fit my quarters and rear window panel, I’ve got a difference in my diagonal measurements of the back window and I believe my passenger side quarter is an 1/8” longer at the rear window panel and I am thinking slicing it like you did is probably the solution.
The 68 quarters i do but the 67 quarters are usually fine .
Similar threads
