• Community Forums
  • Regional Forums and Event Information

ACCELERRATION

  • Thread starter Thread starter 86crazyhorse
  • Start date Start date Feb 23, 2008

86crazyhorse

New Member
Mar 22, 2006
29
0
0
clackamas Or
Feb 23, 2008
#1
  • Feb 23, 2008
  • #1
NEAT READING FOR ALL CAR BUFF'S

THIS IS ABOUT SPEED---


"DEFINITION OF ACCELERATION"
... Fun Stuff !
(courtesy of KB Performance Pistons)







One top fuel dragster 500 cubic inch Hemi engine make more horsepower than the first 4 rows of stock cars at the Daytona 500.

It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA Top Fuel dragster engine to reach the rear wheels.

Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro methane per second; a fully loaded 747 consumes jet fuel at the same rate with 25% less energy being produced.

A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster's supercharger.

With 3,000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition.

Cylinders run on the verge of hydraulic lock at full throttle.

At the stoichiometric (stoichiometry: methodology and techno logy by which quantities of reactants and products in chemical reactions are determined) 1.7:1 air/fuel mixture of nitro methane, the flame front temperature measures 7,050 deg F.

Nitro methane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.

Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.

Spark plug electrodes are totally consumed during a pass. After halfway, the engine is dieseling from compression, plus the glow of exhaust valves at 1,400 deg F. The engine can only be shut down by cutting the fuel flow.

If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half

In order to exceed 300 mph in 4. 5 seconds, dragsters must accelerate an average of over 4G's. In order to reach 200 mph (well before half-track), the launch acceleration approaches 8G's.

Dragsters reach over 300 miles per hour before you have completed reading this sentence.

Top fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load.

The redline is actually quite high at 9,500 rpm.

Assuming all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second.

The current top fuel dragster elapsed time record is 4.428 seconds for the quarter mile (11/12/06, Tony Schumacher, at Pomona, CA). The top speed record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony Schumacher, at Hebron, OH).

Putting all of this into perspective:

You are driving the aver age $140,000 Lingenfelter "twin-turbo" powered Corvette Z06. Over a mile up the road, a top fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and pass the dragster at an honest 200 mph. The "tree" goes green for both of you at that moment.


The dragster launches and starts after you. You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds, the dragster catches and passes yo u. He beats you to the finish line, a quarter mile away from where you just passed him.

Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course.

... and that my friend, is ACCELERATION !
 

90STANGPONY

New Member
Feb 16, 2008
6
0
0
Feb 23, 2008
#2
  • Feb 23, 2008
  • #2
WOW! now that is a whopper of a way to explain acceleration. So incredible to think that can actually happen. Very nice story.
 

almostblown

New Member
Dec 16, 2005
109
0
0
Feb 23, 2008
#3
  • Feb 23, 2008
  • #3
Oldie, but goodie.
 
T

TURBO80LXCOUPE

New Member
May 31, 2007
20
0
0
Feb 27, 2008
#4
  • Feb 27, 2008
  • #4
thats awsome now oly if i could afford a funny car or even a mountin motor pro stock
 

DNA DOA

Member
Apr 3, 2005
184
0
17
Scappoose
Feb 28, 2008
#5
  • Feb 28, 2008
  • #5
"... and that my friend, is" AWESOME! Good read.
 
A

autoX

New Member
Jan 27, 2003
30
0
0
Feb 29, 2008
#6
  • Feb 29, 2008
  • #6
I heard the crank will twist ~20 degrees from the front to the rear of the crank. Since that messes up the camshaft timing, they machine the camshafts with a "twist" in them as well so that when the crank loads up and twists the motor will still have the proper valve timing...

Not sure if it's true, but I heard it so it must be.
 
You must log in or register to reply here.

Similar threads

0
'04 V6 running rich excessively on both banks
  • 04DSGVert
  • Oct 26, 2025
  • SN95 V6 Mustang Tech
Replies
2
Views
288
SN95 V6 Mustang Tech Oct 27, 2025
04DSGVert
0
X
Free VE Table Corrections — Drop Your MSQ and a Datalog, I'll Do the Rest
  • X-cam34
  • Apr 12, 2026
  • Digital Self-tuning Forum
Replies
8
Views
257
Digital Self-tuning Forum May 21, 2026
X-cam34
X
Engine 1990 LX 5.0L EFI Mustang Fuel Management Problems - HELP!
  • 5.0LXStanger
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
45
Views
2K
Fox 5.0 Mustang Tech Jul 11, 2025
5.0LXStanger
Tips for WUE and ASE tuning
  • Mustang5L5
  • Oct 9, 2025
  • Digital Self-tuning Forum
Replies
1
Views
456
Digital Self-tuning Forum Oct 10, 2025
gkomo
X
VE Table Not Dialed? Send Me Your Datalog.
  • X-cam34
  • Feb 8, 2026
  • Digital Self-tuning Forum
  • 2 3
Replies
49
Views
1K
Digital Self-tuning Forum May 1, 2026
X-cam34
X
Share:
Bluesky Email Share Link
  • Community Forums
  • Regional Forums and Event Information
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?