Adjusting the Clutch Cable?

Black Sun 5.0

Founding Member
Mar 23, 2002
1,337
0
36
L.I., N.Y.
I just installed my new MGW shifter and I appear to be getting a bit of grinding, mostly when going into second and definitely third gear. I just had a clutch cable installed about 3 weeks ago and was thinking it may need to be adjusted. How is this done?
 
If you have the stock quadrant, pull up on the pedal with your foot, then push it in to the floor. It may take a few times for it to get adjusted. If you have an aftermarket quadrant and firewall adjuster, you adjust it by turning the firewall adjuster in or out. I don't know if it will solve your grinding problem, but it is worth a try.
 
Without the car running: Try shifting with the clutch pushed in. If you have problems shifting without the car running then it is the clutch.

Adjust it as described above.

If you can shift with the car off you most likely have a transmission that has syncro's that are going bad.
 
Did your new shifter come with stops on the base? Did you adjust them ( I am sure you did, but I have to ask for the sake of clarity)

If the syncro's start to go, the car is still driveable, but you will need to start saving up for a tranny.
 
If what the car is doing is the synchros, it's not driveable. I'll have no clutch in about a week. Yes, the stops were set correctly, but this really shouldn't interfere as long as they're not too close to the shifter.
 
How was the clutch's freeplay?

Did the new shifter get the plastic cup transfered onto the throw-rod?

Good luck.
 
Yes, I did move the cup over with the new shifter. But on a funny note, it MAY have just been my driving. I just had the car out after adjusting the clutch a few times. I took my time with the shifts and it wasn't giving me a problem. Something tells me I'm just not used to the shorter shift when compared to the stocker. Time will tell.