Aftermarket Chip Install...

[2000 4.6]

Hey, I am getting ready to install a chip (Kenne Bell) on my 2000 GT and someone told me that the bolts holding the stock computer in were a wierd size. Does anyone know what size and how many, etc? Thanks!

Bryan

 

[blue46gt]

I just did my chip and I know they are metric, I think they are 3.5mm, there are 2 that you will have to take out to get the wiring out of the way. and then 1 thats bigger on the computer main harness i think it was 10mm.

 

[blue46gt]

Ok scratch that. Just went out to the shop to check for sure. There is 2 bolts on the bracket holding the 3 wiring harness clips that you will have to remove first(they are 5.5mm). Then you will have to remove the big main wire harness that is on the bottom of the computer(10mm). then remove the 1 screw holding the computer bracket in place(7mm).

 

[2000 4.6]

Great, thanks blue46gt...that is exactly what I needed!

Bryan