Aftermarket fuel rails, whose running them?

I have a set of aftermarket fuel rails im installing right now. Because i still have the stock distributor i had to grind a little on the fuel rails and trim the distributor a little to get the one side to fit at all.. They rub are touching now but i don't think it will cause any problems?

What brand of fuel rails are people running and do you have the same problem im running into? I have a set of 1/2 ID Proffessional Products. If so what did you do? Different distrubutor?

Currently the rails are spaced out a little. It looks like there is a good seal on the injectors but i won't know for sure till i start it up. It got dark and i started the prodject outside so i didn't even get a chance to put some pressure to the system to check the lines.

Also where did you mount the bypass regulator?

ttt

Well everything sealed which was surprising.

Far as noticable changes.. Im gonna have to say HELL YEAH...

I use to rev the motor and my fuel pressure would go down then come back up.. Very strange... Now its just the opposite.. The fuel pressure goes up and then smooths back down... And my throttle responce is like double now..

Car is a little scary right now especially on the wet pavement today.. I spun accidently at like every stop sign and light.