i posted this in tech also, but figured someone local might have an idea. i put a whole 15 miles on my engine that took 4 weeks of aggrivation to finish. then a head gasket blew, last 2 nights ive been doing that.
tonight im almost done and tightening the nut on my edelbrock intake and the wrench falls down into the oil pan. 1/2" wrench, right through the rag i had covering it.
is there any kind of magnetic divice i can use to get it? if not im done with this car. pulling the motor isint an option at this point. looking for any other resolution that gets this hunk of rat **** moving again.
tonight im almost done and tightening the nut on my edelbrock intake and the wrench falls down into the oil pan. 1/2" wrench, right through the rag i had covering it.
is there any kind of magnetic divice i can use to get it? if not im done with this car. pulling the motor isint an option at this point. looking for any other resolution that gets this hunk of rat **** moving again.