I'm not sure what is wrong, but my pedal is soft. I've bleed a few times, new fluid, etc. and still soft. When I put it on the road, I used a residual valve recommended by MP Brakes for the front discs. A couple miles down the road, the passenger caliper locked. When I loosened the bleeder, the caliper released.
I replumbed without the residual valve using the front two ports of the factory (drum) dist block. The pedal will not get solid as it was before (it goes to the floor basically).
I clamped each soft line going into the calipers and when I did the ft passenger, I got the solid pedal. I'd assume the caliper is bad, but I see no leaks and the piston will go out and in.
Is it the caliper? Distribution block? Thoughts?
Thanks!
I replumbed without the residual valve using the front two ports of the factory (drum) dist block. The pedal will not get solid as it was before (it goes to the floor basically).
I clamped each soft line going into the calipers and when I did the ft passenger, I got the solid pedal. I'd assume the caliper is bad, but I see no leaks and the piston will go out and in.
Is it the caliper? Distribution block? Thoughts?
Thanks!