Sometimes on idle, my CAI (fender mount) is knocking up against my shock tower. I can hear it from inside the car. The pipe bend at the throttle body is pretty close to the tower, so much I can't put my finger between them. I have had it installed about a month, did I do something wrong?
It's not uncommon for the BBK pipe from the throttle body to mass air sensor to require @ 3/4" to be cut off. Or, try shoving it closer to the throttle body inside the rubber coupling, or even check your motor mounts, especially since the engine torques from right to left.....
It's not uncommon for the BBK pipe from the throttle body to mass air sensor to require @ 3/4" to be cut off. Or, try shoving it closer to the throttle body inside the rubber coupling, or even check your motor mounts, especially since the engine torques from right to left.....
Yeah my MAC did the same thing and i noticed that it basically was just a little loose/sloppily installed. The BBK might be a bit different, but for mine i just had to shove it as close to the TB as possible and clamp it there tight. It's kindof a scary sound if you hear that thing knocking before you know what it is lol...
Yeah my MAC did the same thing and i noticed that it basically was just a little loose/sloppily installed. The BBK might be a bit different, but for mine i just had to shove it as close to the TB as possible and clamp it there tight. It's kindof a scary sound if you hear that thing knocking before you know what it is lol...
Yea I know what you mean, I coulda swore I had a serious motor issue when mine knocked, a little nervice at first. I fixed it by just playing around with, the rubber couplers until it worked. I also took out a TB spacer some dummy had added.
I had to tweak the crap out of mine. Also I "borrowed" some self adhesive soft rubber/ foam from work and attached just enough to prevent any knocking I would hear.