bbk header fitment prob.

notguilty411

New Member
Apr 27, 2005
21
0
1
went out and figured id try and install a set of bbk unequals i picked up from a friend for $5. and i cant get the passenger side to line up for anything. did anyone else have any problems with these same headers? i thought bbk was pretty good as far as fitment went?? so yeah can anyone give me any suggestions as far as getting them on? its starting to piss me off to the point where i want to just throw the stockers back on.
 
I believe you have the separate flange headers which I have too. Those headers get "use" to the engine they came off are are a pain to put on another. I switched to AL heads and it was a nightmare. It takes a bit of prying. I used a piece of wood so I don't mar too much and on top of that be careful if you have aluminium heads. Don't want to strip any of the bolt holes in the head. Next time they have to come off im getting some one piece flange FMS headers... take that back... can't support ford right now.
Kevin
 
lol about not being able to support ford.. i work for them and sometimes i think twice about it. but yeah the motor is out of the car at the moment and we have the driver side header on, the passenger we have everything except the one end bolt towards the rear of the motor. its really starting to piss me off... so we'll see if tomorrow morning we can get it in.
 
IIRC, all BBK headers have a single flange (correct me if I'm wrong). Are you sure they're BBK's?


I have BBK UE headers (single flange) and they were super easy to install. Do your's have individual flange's?
 
SeventyMach1 said:
IIRC, all BBK headers have a single flange (correct me if I'm wrong). Are you sure they're BBK's?


I have BBK UE headers (single flange) and they were super easy to install. Do your's have individual flange's?


The older ones had individual flanges, newer ones are one piece. Not sure when they made the switch though
 
notguilty411 said:
lol about not being able to support ford.. i work for them and sometimes i think twice about it. but yeah the motor is out of the car at the moment and we have the driver side header on, the passenger we have everything except the one end bolt towards the rear of the motor. its really starting to piss me off... so we'll see if tomorrow morning we can get it in.

If 1 bolt hole doesnt line up, get your drill out and open it up a little bit. It's a single flange so i don't understand how your going to pry it over. If i'm not mistaken it's like 1/4" thick steel. This is all assuming you don't have individual flanges like Mac's.