Bellhousing won't come off

oz · Dec 23, 2011

Greetings,
I'm in the process of putting on a new clutch (5.0 w/ T-5) and I can't get the bellhousing loose. I took all 6 bolts out and I think the dowel pins are just rusted fast. I don't want to hammer it and break it and I can't get any kind of wedge in the right place to drive it apart.
I'm thinking I may need to use a hand torch and heat up the dowel area to get it to let go.
Are the dowel pins pressed into the block or the bellhousing? I need to know this I guess if I decide to try the torch option.
Any other suggestions?

Thanks.

Jason 302 · Dec 23, 2011

Do you have a rubber mallet? Keep working on her. Try and spray a little WD down where the dowel pins are. They are pressed into the block but I've seen them come out with the bellhousing before

jrichker · Dec 23, 2011

Be sure to remove the starter, it helps to hold the bellhousing in place. Once it is out of the way, place a wooden block over the starter opening and give it a hard smack. That should shake the bellhousing loose from the block. Be sure that the bolts for the bellhousing to steel sheet spacer have been removed too. Tapping on the area where they fit can also help shake the bellhousing loose from the block.

oz · Dec 24, 2011

Thanks for the suggestions. I'll give them a try.

Bellhousing won't come off

oz

Jason 302

jrichker

StangNet's favorite TOOL

oz

Similar threads

Bellhousing won't come off

oz

Jason 302

jrichker

StangNet's favorite TOOL

oz

Similar threads

Privacy & Transparency

Privacy & Transparency