bumping my timing

belzebub2u · Nov 10, 2004

I was going to check my timing and bump it to 14* but i do not see a plunger on the front of my dist, am i just looking in the wrong place?

also another question, would i be better off to buy a gt40p set of heads and intake, or just get a late 90's explorer motor with low miles since my engine has 187k on it?

HISSIN50 · Nov 10, 2004

i thought your guys' SPOUT connector was under the air inlet tube/MAF?

moneypit94 · Nov 10, 2004

HISSIN50 said:
i thought your guys' SPOUT connector was under the air inlet tube/MAF?

It is...

Just undo the spout connector that over by the maf.

Second Question: It depends... Depending on how mechanically inclined you are you could aways just get a rebuild kit and freshen up your motor. (rings, bearings, etc.) If your worried about it.

But if your gonna be basically putting on the same parts anyway it is a matter of which one is worth messing with to you...

bumping my timing

belzebub2u

New Member

HISSIN50

"How long does it take to get help in here?

moneypit94

Active Member

Similar threads

bumping my timing

belzebub2u

New Member

HISSIN50

"How long does it take to get help in here?

moneypit94

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency