What did you do as far as the condenser so it was not a problem? My cam is being swapped soon I want there to be as few issues as possible.
Cam swap in car.
- Thread starter XxFaceYourFear
- Start date
What did you do as far as the condenser so it was not a problem? My cam is being swapped soon I want there to be as few issues as possible.
Blackened302
Active Member
took out the NX282HR and put in a TFS stage 1. also put in a new timing chain set.
unbolt the two condenser brackets up top (one on each side), pull it out just a bit so you can move it around, then you can bungee it up, tie it, or just hold it out of the way.
unbolt the two condenser brackets up top (one on each side), pull it out just a bit so you can move it around, then you can bungee it up, tie it, or just hold it out of the way.
awesome sounds good
+1 on doing the timing chain, might as well since you are in there. How do you like the TFS Stage 1 so far?
Blackened302
Active Member
well, i'm not sure.. i haven't driven it yet. it's been a busy last few days, including getting all this work done. probably won't mess w/ it again until next weekend. looking forward to the stock-like driveability!
