Carb Lower Intakes With Injector Ports?

[tjh566]

Anyone seen any decently priced? CHP has some but $500 damn, Not sure if ill even need one just wanna look into it for now, I think im ok on my intake setup just lookin at options.

 

[SQUEEZE&STROKE]

Just the spyder...you can make your own if you have some good tools...just drill the bungs and you can buy the spyder elbow separately.

 

[BlackVert]

killercanary just told me today that rnh performance has canfield ones, i don't know what they cost tho

 

[1TallMF]

The Spider one is hawt
But like the others, it 'aint cheap. I think edelbrock makes a few of their carb intakes that can be drilled for injectors, IIRC they have a special designation on the part #.

 

[ProKiller]

yeah check out the victor jr. intakes, i think they have them

 

[Green 94 5.0]

well that would definitely solve your uneven flow worries.....

 

[1TallMF]

I was bored at work so I found thes on the Jegs web site:


Super Victor 8.2 EFI (302) Manifold (4500 - 9000rpm) $403.99

Super Victor 351W EFI Manifold (4500-8500rpm) $369.99

Victor FE EFI Manifold (351W) (up to 8000rpm) $562.99

no pic


There are more, and they go even higher in price. You can see all of them here
Looking at the specs, these types of manifolds don't seem exactly suitable for a street car.

 

[tkelley]

heres one. Just take it to your local machine shop and have it drilled.
http://cgi.ebay.com/ebaymotors/INTA...0-302-EFI_W0QQitemZ330079557539QQcmdZViewItem

T

 

[SQUEEZE&STROKE]

The supervictor is way to big for a stock bottom end. Go for a dual plane or very small runner single plane.