Clutch help

[tlpilot]

I finally got around to putting the t5 in the 2.3. I have what I believe to be the SVO bellhousing. It has a little mini cable that pulls the clutch fork. This little cable is hooked to arm that attaches to the clutch cable.

What type of connector do I need to connect the cable to the pivot arm on the side of the bell housing?

I have the four wires that plug up to tranny but do I jumper the two that I don't need to each other?

Any help is appreciated.

Thanks,


Brew

 

[goland55]

Does your clutch cable have a ball end to it? If the svo bell is like the other 2.3 bells then you should be able to connect that ball end to it. If you happen to have a 5.0 clutch cable (threaded end I believe) it won't work without modification (if it can work at all, I dunno).

From what I know you jumper the two wires that aren't used. If you haven't. I suggest you check out stinger's write up on the swap here: http://www.stinger-performance.com/howto.html