come on need help pro m

noslow1986

New Member
Mar 25, 2006
274
0
0
oswego Il
is a 80mm to big i have trick flow intake and cold air induction and 70 mm throttle body gears pulleys and msd ingition and other bolt ons i already purchase it form ebay it said for 19 or 24 injectors what should i do i dont like c and l. did i just waste a hundred dollars
 
Start researching before you buy stuff or you'll waste tons of money.

The pro m sensor should be calibrated for either 19 or 24 lb injectors, not both. Mine has the calibration on the top engraved in the plastic. The most important thing is that it is calibrated for the size injectors you have. Secondly, don't make the mistake of putting a Pro M sensor on a C & L MAF tube because they aren't interchangeable.

Lastly, I'm no expert, but I'd say the 80mm MAF tube might be a little big for your combo. You might not make as much power as you would with a smaller one, but I'm not sure what else it would cause.

What size injectors do you have?
 
The 80mm should do fine, but as said above it can only be programed for one size injector only i'm sure that is your problem. find out what the proper size it needs or you may have wasted money on a product that is no longer made by a company that is no longer around. (was a great company)
 
The Pro-M 80mm will be calibrated for only 1 size injector, not 2 like stated.

You will not loose ANY power by it being too big, even if your motor was bone stock it is not too big.

If you can not read the numbers and figure out which calibration it is then you can send it back and they can tell you what calibration it is for.
 
If time is of the essence, try emailing them or even better calling them. Give the code on top of the MAF and they should be able to answer that for you.

With it being an MAF, I wouldn't say it would hurt your power. You don't need the flow now, but you could later. Good Luck with the outcome.