Control Arm Bushings Breaking

93gtmustang

10 Year Member
Oct 21, 2006
524
43
49
I have BMR adjustable upper control arms and lowers.
My upper bushings are broke apart at the body connections.
Also the drivers side lower is cracked at the body connection.
What would cause this?
They were put on Jan. of 2006
I drag race this car, but it is not really high power.
Ford Racing GT-40 Crate Motor with a 5 speed.
Thanks
 
I called BMR. They said that you have to use synthetic grease with their polyurethane bushings
Regular grease with eat away at them and cause them to break down.
That's most likely the problem.
I didn't install them so I don't know what kind of grease was used
 
I installed both upper and lower BMR arms and greased them with synthetic about 6 months ago. Now I am and feeling a pop in the left side under hard accelleration and decelleration. I was under the car last week, but didn't see or notice anything out of the ordinary. I also have BMR subframes as well as a Steeda tower brace, so there shouldn't be any popping from body flex. My motor is still near-stock, and shouldn't be shredding suspension parts.....I hope BMR didn't scrimp on the bushings! :shrug:
 
BMR said they did have a defective batch of bushings a while back. Mine were installed Jan. 2006 . The defective batch was just recently. I'm sending my old bushings to them anyways to see if they are defective.
 
Mr Grim,
You said you installed them yourself.
Was it hard, did you do it on a lift or jack stands.
I'd like to save myself some money if I could change the bushing myself.
If you could tell me how you changed them and any other tips on changing the bushing would be greatly apprecited.
Thanks
 
Swapping the new arms for the old was a snap...Just do one at a time.
I put the car on stands, then unweighted the axel with a floor-jack. Just use the jack to help work the arms into position.
The only time consuming part is getting the old rubber bushings out of the rear-end housing. Someone else did mine, but you can either drill them out, or burn them out with a torch....clean up the shells, and pop the new ones in. Be sure to grease them after the install...easy to forget.
Good luck! :nice:
 
Does anyone have detailed info on changing upper and lower control arms?
I have BRM uppers and lowers on my car right now.
The bushings are shot. They are the polyurethane type.
I have to take the old bushings out and put the new ones in.
Jacking? Pinion Angle? ( Uppers are adjustable) Take one out at a time?
Getting old bushings out, putting new ones in?
Thanks
 
Just finished putting in the new bushings.
It's hard work using jack stands.
If anyone needs any help with this, I'd be more than happy to give some tips to make it easy.