CR-1 wide and roll cage

[jfanoe]

So I'm thinking about putting in some racing seats and a roll cage soon as my car is due for some mods. I want to get the Corbeau CR-1 wide seats, but I'm unsure as to whether or not they will fit with a roll cage. I was just wondering if anyone has had any experience with these seats and a cage. Also, does anyone know where that roll cage/bar from the yellow Ground Designs Cobra came from. It's the only one that I've seen that will work with a tonneau. Thanks in advance.



-J


edit:
I meant to say a 6 or 8 point bar

 

[Got N2O]

Dude go with a custom bar. There is NO SUCH THING as a bolt in 'vert roll bar (light bar yes, roll bar no) because the area behind the rear seat has to be reinforced with weld in plates. I bought the maximum motorsports bar (which I love!) but after $400 for the bar $100 for the freight charge (comes on a pallet) and $300 for the installation (I had it permanently welded in) I could have just gotten a custom job. And it will clear any seats, etc. that you have because it's made for YOUR car.

 

[jfanoe]

Thanks for the advice. I was intending on welding the bar in, in the first place. I guess I should have put that in my first post. I'll probably end up going with a custom job now. THanks again.