Did it

tag4car

Member
Nov 21, 2005
0
0
16
Birmingham AL
Stg IV is on the car now!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!:D

took me about 5 +/- hrs total, cleaned the actual intercooler hella good, all ugly colored and cleaned the iat2 sensor also, was oily :(


Very nice Sotp improvement, Very Nice Sound :drool:

Waiting now to swap the pulley and tuning. cannot wait.:nice:
 
Update



tr6 plugs are in, and really smoothed out the low end even more. Now i'm enjoying a belt squeal with everything i do, if i spray it down with belt dressing spray it stops. Wtf now? i have to get a different belt for the 3.10 pulley and now apparently another stock for the 2.76 because it's deciding to crap out?
 
Do you have a Steeda (or any brand) idler pully for it? My Cobra squealed like crazy untill I put one of them on it. After that I never once heard it slip. :nice:
Also, the gatorback belts have more bite.
 
i have the complete billetflow set, 4pc and tensioner. i'll see what math number i can come up with to be able to put the tensioner on and keep the stock pulley for a little bit. Everybody i've seen says gates are thicker.??

thx bill
 
Pulley now swapped. Rented Billetflow's substantial tool and pulled it right off, then the new hub went on. However. I couldn't find anyone in town that had a 75.5" serpentine belt in stock so i had put the 2.76 and the same damn belt back on until the belt arrives. i have it tuned 10% richer and -spark at all rpms until