do i have gears!

Makdaddymac

New Member
May 28, 2005
323
1
0
orlando
I bought my fox, been driving it. Its fast in comparison to my probe 4cyl and blazer that use to drive.I was guessing that since My tach jumps a lil, and so does my speedomter(has to be off) do i have non oem gears?. Iwas wondering maybe, if someone could tell me a a rpm range for factory driving. Or any way to find out.
 
Put the rear of the car up on jackstands.
Rotate the tire one revolution while watching the driveshaft. Count how many revolutions the driveshaft makes for one revolution of the tire.
If the driveshaft makes about 3 and 3/4 revolutions to one revolution of the tire than you should have 3.73s. If it is about 3 1/2 revolutions then 3.55s, a little more than 4 revolutions 4.10s and so on.
 
the jump is probably old grease or dirt in the speedo. but yea those methods work for finding the gear ratios, also a blazer and probe are slow compared to a stock 5.0, so i don't think that that matters.
 
OT but my speedo cable has burned but my old exhaust, so my speedo is strange, bouces around some and anything over 90-100 it goes erratic. In the cold weather its even worse. will lose it at like 50-60
 
with my 327's i am at 2400rpms at 75mph, thats by my gf riding beside me in her truck b/c i have yet had time to toss in the speedo recal. gear. Thats with the stock tach so i could be really at like 2250, but from the exhaust note i would say its pretty damn accurate at those rpms...