Realmongo I prefer to be called "Evil Genius" Founding Member Oct 10, 2001 2,466 86 99 Western Mass Oct 15, 2005 #1 Oct 15, 2005 #1 The Chiltons manual says to torque the bolts securing the driveshaft to the rear axle flange 70-95 foot pounds. Is this correct? It sounds way too tight!
The Chiltons manual says to torque the bolts securing the driveshaft to the rear axle flange 70-95 foot pounds. Is this correct? It sounds way too tight!
D Daggar New Member Jul 19, 2004 3,902 5 0 Oct 15, 2005 #2 Oct 15, 2005 #2 It's not too tight. I've always used the calibrated "Good-N-Tite" method from the longest breaker bar I had at my disposal.
It's not too tight. I've always used the calibrated "Good-N-Tite" method from the longest breaker bar I had at my disposal.
BlownFiveLiter have car, will race....wait, it doesn't run 15 Year Member Nov 29, 1999 3,133 18 108 Chicagoland Oct 15, 2005 #3 Oct 15, 2005 #3 Sounds right. My Haynes manual calls for 85, and I always do that plus red loctite.
blackstangt Member May 31, 2004 460 1 19 ny Oct 15, 2005 #4 Oct 15, 2005 #4 def that much, and use loctite
B bimmertech New Member May 3, 2005 1,123 0 0 merriam, ks Oct 15, 2005 #6 Oct 15, 2005 #6 that's about a 2 grrr torque rating
Shakerhood 20+ Year Stangneter Oct 28, 2004 3,361 211 114 Ohio Oct 15, 2005 #7 Oct 15, 2005 #7 The Ford Service Manual calls for 71-95 Ft. Lbs. and to replace the bolts. The Ford Bolts come precoated with Yellow Loctite.
The Ford Service Manual calls for 71-95 Ft. Lbs. and to replace the bolts. The Ford Bolts come precoated with Yellow Loctite.
Realmongo I prefer to be called "Evil Genius" Founding Member Oct 10, 2001 2,466 86 99 Western Mass Oct 15, 2005 #8 Oct 15, 2005 #8 Wow all, thanks. I am really surprised, I tought it was a misprint!