I got the stock cam out but cant get the damn dowl out of the end of it to put in the new cam. Im guessing it just pulls staright out, i used mapp gas and then vise grips and it wouldnt budge anything im missing
its the little pin in the end of a cam that goes into the timing gear to turn the cam. not sure if FTI sends one...but im pretty sure any cam you buy will come with a new one.
I did this recently. The dowel pin came out of my stock cam no problem.
The TFS cam came with 2 dowel pins (dif lengths). I used the one that was the stock size. Now to get it in I took a rubber mallet and whacked it a few times as it was a tight fit. If you can't get it out, im sure you can pick up one cheap somewhere.
I went by O'reillys, autozone and local hotrod shop and noone had them I keep soaking it in liquid wrench and about to try some more. This sucks i always get hung up on the lil stuff.