Drill & Tap size.

94GTCoupe

10 Year Member
May 7, 2006
1,412
92
79
CA
i want to tap my explorer intake for the ACT sensor on the #5 intake runner.

i did a search for the drill and tap size and found that i need a 9/16 drill bit and a 3/8 NPT tap.

is this correct?i just want to double check,i did not have a chance to run to the JY to get an ACT sensor to get the exact sizes.

i have a 94 GT and i know my car don't need the intake tapped for the ACT,but i have two intake's,one's going on my car and i'm going to sell the other.

thank's,Davis3.
 
9/16 will work fine, its only .015" smaller than a 37/64, just use plenty of lubricatnt when tapping the thread, chamfering the hole good before you tap will help get the tap started. run the tap all the way in until you have 3 threads left on the tap stickout out of the hole still.

good luck.