Dust Shields or no Dust shields.

Blueinfan · Dec 6, 2021

Hi Mustang Enthusiast,

I have two questions for all you.

1. I've upgraded my 1991 LX 5.0 convertible from 4 lugs to 5 lugs. Now I have purchased some dust shields for it. What are the benefits of installing them and not installing them?

2. The brake tubing that is above the axel and connects the brake line to the rear got bent when I was trying to remove the fitting nut. I've purchased some stainless brake lines from LMR but the problem is that there are several steel plates that I need to remove and sand the rivets off , and rerivit to properly install the new brake line.

So, my question is, can I just cut a certain length off and connect another line to it without having a safety concern. Or bite the bullet and sand the rivets off, and install te new lines?

thanks,

90sickfox · Dec 6, 2021

The dust shields help keep dirt and stuff from getting on the rotor. If it isn't a daily driver you don't really need them. I don't know about you but the only way my car sees rain is by mistake.

Wayne Waldrep · Dec 6, 2021

Mine had the factory ones till almost 50k miles. The next 350k miles i never put them on. Still new on the shelf...lol. Zero difference.

Gs1987GT · Dec 7, 2021

90sickfox said:
The dust shields help keep dirt and stuff from getting on the rotor. If it isn't a daily driver you don't really need them. I don't know about you but the only way my car sees rain is by mistake.

Agree with 90sick. Unless your running a lot of miles, it's your DD or whatever, you dont need them. Mine also is a shop queen and not driven in the rain, unless its unforeseen.

Mustang5L5 · Dec 7, 2021

If you have them run them. If you don't, don't sweat it.

If this is a car you plan on putting a lot of miles on, i would probably say to run them

Blueinfan · Dec 7, 2021

Mustang5L5 said:
If you have them run them. If you don't, don't sweat it.

If this is a car you plan on putting a lot of miles on, i would probably say to run them

just going to be one of those cars that are parked in the garage and don't see the rain. Only comes out on the weekends and is towed to car shows. Not a daily driver right now. Maybe when I coyote swap it might see more miles but a daily car.

7991LXnSHO · Dec 8, 2021

Question 2. If a brake part needs replaced, do it right. Driving with the parking brake only in an emergency is no fun.

manicmechanic007 · Dec 11, 2021

You will not notice them missing until you hit a Yuge puddle of water
If you get drilled or slotted rotors you will not notice the difference in braking as much
They will only fade for a moment

Bree · Dec 11, 2021

Open rotors = better heat dissipation.

KRUISR · Dec 14, 2021

I don't run them. If you have bigger rotors, finding the right size would definitely be a pain.

Blueinfan · Dec 14, 2021

so then what's the whole purpose for the dust shields if they are not needed. I bought them because the car came with them. The car will not be a daily driver. Just a weekend and show car. Or maybe drive along the California cost once a month

Mustang5L5 · Dec 14, 2021

Blueinfan said:
so then what's the whole purpose for the dust shields if they are not needed. I bought them because the car came with them. The car will not be a daily driver. Just a weekend and show car. Or maybe drive along the California cost once a month

It’s a debatable question really. Keep in mind when Manufacturer sends a car out of its factory, they have no idea what the owner will do to it, so the shields are for various reasons that you may or may not ever experience.

Over the years, I’ve settled on a few possible reasons. These are my opinion and not a de facto answer.

Splash protection from running though deep puddles at speed

Protect various suspension components from heat generated during braking.

Protect the rotor surface from any grease/oil/etc that may inadvertently spray onto it from various suspension and engine components. (Busted CV axle boot for example)

Prevent the corrosive brake dust from settling on suspension components where, after 100k miles, it might pose an issue.

With all that said, I do run them on my car on all 4 wheels. I don’t actually think I need them based on my driving conditions/habits

General karthief · Dec 14, 2021

And you can mount those silly LED lights to them

junkyardwarrior · Dec 15, 2021

look closely at the 'dust shields'

on the back of them (facing inward and forward) are air deflectors that help draw air into the center of the rotor. As the rotor rotates and the vehicle is moving forwards, it helps move air from the center outward, sort of like the way a turbocharger compressor wheel moves air from the center out. Those deflectors (dust shields) help that air to flow, which helps keep the rotors cool. They are often bent, often broken, missing, or rusted away should you be looking in a junkyard. SN95 dust shields are almost all riveted to the spindle, and getting them off in a junkyard is no fun unless you have a grinder or a drill. Even then, most of the time they're damaged when they put the car down on the ground without any rims or tires on it. I always put them back on if possible.

Blueinfan · Dec 18, 2021

junkyardwarrior said:
look closely at the 'dust shields'

on the back of them (facing inward and forward) are air deflectors that help draw air into the center of the rotor. As the rotor rotates and the vehicle is moving forwards, it helps move air from the center outward, sort of like the way a turbocharger compressor wheel moves air from the center out. Those deflectors (dust shields) help that air to flow, which helps keep the rotors cool. They are often bent, often broken, missing, or rusted away should you be looking in a junkyard. SN95 dust shields are almost all riveted to the spindle, and getting them off in a junkyard is no fun unless you have a grinder or a drill. Even then, most of the time they're damaged when they put the car down on the ground without any rims or tires on it. I always put them back on if possible.

Found it!!!

Thank you!

Dust Shields or no Dust shields.

Blueinfan

Active Member

Attachments

90sickfox

Wasn't a pretty sight...and I've got big hands

Wayne Waldrep

Before I post a pic, do you have one of yours?

Gs1987GT

Active Member

Mustang5L5

That is…until I whipped out my Bissell

Blueinfan

Active Member

7991LXnSHO

wanna catch the space herp

manicmechanic007

Bree

Active Member

KRUISR

Blueinfan

Active Member

Mustang5L5

That is…until I whipped out my Bissell

General karthief

wonder how much it would cost to ship you a pair

junkyardwarrior

Well-Known Member

Blueinfan

Active Member

Similar threads

Dust Shields or no Dust shields.

Active Member

Attachments

Wasn't a pretty sight...and I've got big hands

Before I post a pic, do you have one of yours?

Active Member

That is…until I whipped out my Bissell

Active Member

wanna catch the space herp

Active Member

Active Member

That is…until I whipped out my Bissell

wonder how much it would cost to ship you a pair

Well-Known Member

Active Member

Similar threads

Privacy & Transparency

Privacy & Transparency