I am in the middle of my Kenne Bell SC installation and it is frustrating me that I can not get the ECU for chip installation.
I have a 2000 GT and I could only get as far as being able to remove the three connectors to get to the ECU. I can not even see half of the module. I still have to disconnect the main ECU connector and then pull the module out. Any suggestions??
I have a 2000 GT and I could only get as far as being able to remove the three connectors to get to the ECU. I can not even see half of the module. I still have to disconnect the main ECU connector and then pull the module out. Any suggestions??
