those were the day b4 i dropped the engine in!.
havent got pics of it in the car yet.... But i am ALMOST DONE OMFG!
got the rails. injectors all plugged in, dizzy stabbed,driveshaft, headers and H-pipe are on, new bullets welded to flowtubes, clutch adjusted, shifter installed, front accesories are all on and connected, radiator in, battery and all the crap
All i have left is the valve covers, upper intake, bolt bullets up, oil and water.
then i will fire her up and set the timing and go break her in!
got some qs. Should i start by filling the engine up with water via the thermostat housing? so i wont have a big air pocket on initial startup.
also whats optimum way to break the engine in??
i've heard many ways. The way i think seems best is to take it out after getting warmed up and go WOT from 20-50 and slow down and repeat 12 or so times. To seat the rings, change oil and drive it (without and sustained speeds) then after 500 miles change oil and again at 2k?
havent got pics of it in the car yet.... But i am ALMOST DONE OMFG!
got the rails. injectors all plugged in, dizzy stabbed,driveshaft, headers and H-pipe are on, new bullets welded to flowtubes, clutch adjusted, shifter installed, front accesories are all on and connected, radiator in, battery and all the crap
All i have left is the valve covers, upper intake, bolt bullets up, oil and water.
then i will fire her up and set the timing and go break her in!
got some qs. Should i start by filling the engine up with water via the thermostat housing? so i wont have a big air pocket on initial startup.
also whats optimum way to break the engine in??
i've heard many ways. The way i think seems best is to take it out after getting warmed up and go WOT from 20-50 and slow down and repeat 12 or so times. To seat the rings, change oil and drive it (without and sustained speeds) then after 500 miles change oil and again at 2k?