Roush Exhaust question

This may not belong here, but it is specific to my Saleen. I had a Prochamber w/ Mac Flowpaths on my 96 and absolutely loved the sound. I can't imagine it would sound any worse with the Borla's. So my question is - with the Prochamber hanging a bit lower than the stock cats, are there clearance / scraping problems with it on the Saleen? I'm at stock Saleen ride height.
Also, I remember the passenger side being a huge PITA to remove on my 96. The window sticker on mine says it came w/ a "Saleen X-pipe." With this "aftermarket" midpipe, is it any easier to remove? Thanks, I haven't had a chance to get it on a lift to check it out, so I was hoping to get some advice from the experience here.
Ken

Thanks, I don't think I have too much fade, it doesn't seem that low, but I guess only time and a midpipe will tell. So how about the install. I had the 96 swap down to a science after switching it about 10 times. Is it any easier w/ the Saleen X? How about the studs w/ the shoulder not allowing a proper seal? I know, search right... I remember reading about it before but blew it off since I had a 96. Thanks again guys.
Ken