I had the 97GT all apart to fix a broken shift fork. It was bone stock, but I decided to install a BBK offroad H-pipe while everything was apart.
The BBK pipe had hangers to use the factory rubber midpipe hanger, and I used these. To make the pipe reach them, I had to jack it up, so there was quite a bit of tension in the rubber hanger when I let them down.
Now, I get a good deal of engine vibration at lower rpms through the car. Anyone had this happen? I suspect it is related to these rubber hangers being streched a bit too far, and transfering the vibration through this mount. Anyone able to say yes, possible or nope?
The BBK pipe had hangers to use the factory rubber midpipe hanger, and I used these. To make the pipe reach them, I had to jack it up, so there was quite a bit of tension in the rubber hanger when I let them down.
Now, I get a good deal of engine vibration at lower rpms through the car. Anyone had this happen? I suspect it is related to these rubber hangers being streched a bit too far, and transfering the vibration through this mount. Anyone able to say yes, possible or nope?