• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Extra Plug Wire?

  • Thread starter Thread starter idaho_88
  • Start date Start date Apr 8, 2006
I

idaho_88

New Member
Dec 1, 2005
15
0
0
Boise,Idaho
Apr 8, 2006
#1
  • Apr 8, 2006
  • #1
So yesterday I put plugs, wires, cap and rotor on. I bought some ford racing wires(red) for the stang. However there is one left and I cannot figure out where it goes. Any ideas? It is about 9-10inches long and one end has a bigger copper center in it. The stang is running fine, but I can't figure what it goes to.
 
J

jerryD

Founding Member
Mar 16, 2000
1,061
0
37
Gladstone, MO
Apr 8, 2006
#2
  • Apr 8, 2006
  • #2
some performance plug wires will come with extra coil wires sometime. not everbody runs the same type of coil or distributor cap. this is what i think.
 

stang8urimport

Autozone Junkie
Founding Member
Jun 21, 2002
1,499
12
59
Daytona Beach, FL
Apr 8, 2006
#3
  • Apr 8, 2006
  • #3
It's the coil wire for older 302s with the coil bolted on the intake manifold, on the passanger side. You don't use it in an EFI Mustang.
 

legalize420

Active Member
May 21, 2005
1,541
1
37
South Florida
Apr 8, 2006
#4
  • Apr 8, 2006
  • #4
there are two different coil wires. you should have one left over.
 
I

idaho_88

New Member
Dec 1, 2005
15
0
0
Boise,Idaho
Apr 8, 2006
#5
  • Apr 8, 2006
  • #5
Thanks guys, that makes me alot less nervous about me forgetting something. Oh, I also have a fuel filter I need to install, it seems a little big, because I have never changed that out in a mustang before. I appreciate the quick responses. :SNSign:
 
J

jerryD

Founding Member
Mar 16, 2000
1,061
0
37
Gladstone, MO
Apr 8, 2006
#6
  • Apr 8, 2006
  • #6
fuel filter is kinda big i think too. about the size of i guess the oil filter as well. it is in front of the gas tank, right about the rear axle i think. peek under there and you will see the lines running to it. be gentle with the plastics if you filter didn't come with new ones.
 
I

idaho_88

New Member
Dec 1, 2005
15
0
0
Boise,Idaho
Apr 8, 2006
#7
  • Apr 8, 2006
  • #7
Appreciate the info. I guess I can go take care of that. Thanks again.
 

302RollinHard

New Member
Sep 26, 2005
0
0
0
Columbus, OH
Apr 8, 2006
#8
  • Apr 8, 2006
  • #8
I would also wait to change the fuel filter first thing in the morning before you have started your car to avoid the wonderful gasoline shower you can get if the system has pressure in it.
 
W

wytstang

Mustang Master
Mar 14, 2004
4,988
4
78
Summerville,SC missing South Fl. weather :(
Apr 8, 2006
#9
  • Apr 8, 2006
  • #9
PoopDawg said:
It's the coil wire for older 302s with the coil bolted on the intake manifold, on the passanger side. You don't use it in an EFI Mustang.
Click to expand...
Wrong (kinda) the shorter coil wire is for the 94/95 coil which sits right above the power steering pump. Foxes coil is near the drive strut tower...
 

Attachments

  • Picture042.webp
    31.8 KB · Views: 188

dkins419

New Member
Nov 14, 2004
187
0
0
Michigan
Apr 8, 2006
#10
  • Apr 8, 2006
  • #10
Be careful when u change that fuel filter. I got the "shower in the face with gasoline" when i did it.
 

srothfuss

Last night I stabbed the same guy 7 times in a row
Oct 17, 2004
1,796
3
0
Woodward Ave.
Apr 8, 2006
#11
  • Apr 8, 2006
  • #11
No matter what you do, gas is going to come out of the fuel line. Just don't be laying right under the filter with your mouth open! Gas is not good tasting.
 

GreatWhite

Member
Feb 24, 2006
232
1
17
Fairfield, PA
Apr 8, 2006
#12
  • Apr 8, 2006
  • #12
Shut off the fuel inertia switch or the fuel pump relay and try to crank the car a few times to kill the fuel pressure in the lines before doing the filter. This will get rid of some of the shower, but some fuel will still drip out... don't lay directly under the filter!
 
You must log in or register to reply here.

Similar threads

Electrical problem plug in the drivers kick panel
  • Mindseye007
  • Aug 16, 2026
  • Fox 5.0 Mustang Tech
Replies
3
Views
244
Fox 5.0 Mustang Tech Aug 16, 2026
Mindseye007
K
Resolved Weird sound coming from a freshly rebuilt 5.0L
  • karhoot
  • Jun 24, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
404
Fox 5.0 Mustang Tech Jun 27, 2026
Mac131
Electrical 91 hatch wiring help needed
  • FastDriver
  • Apr 7, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
275
Fox 5.0 Mustang Tech Apr 8, 2026
FastDriver
R
electrical plug identification
  • redlineracing1328
  • Jun 11, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
167
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 12, 2026
keel
M
1996 GT Speedometer electrical nightmare
  • moon96gt
  • Oct 7, 2026
  • SN95 4.6L Mustang Tech
Replies
2
Views
195
SN95 4.6L Mustang Tech Oct 17, 2026
CAMTWO1070
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?