FAST XFI Stand alone EFI.

Does anyone have experience with FAST XFI stand alone? I am looking really hard at buying a stand alone setup for a project I have going on. I was wondering if seperate rev limiters can be set on a single tune, specifically how many? I need to set at least 4 if not 6 rev limiters for my application. I have a built lightning motor that is most likely going to be topped by a 3.4 Whipple. Its going into a rear engine dragster and will be backed by a poweglide (SP?) trans. I need to set seperate reve limiters for burnout, stagged and the 1-2 shift as well as the top end.

Does anyone have an reccomendations? I'm not dead set on anything at this time, I just need something that will work for my application. I have also looked at the Big Stuff 3 setup and am impressed by it as well. Any feedback would be helpful.


Jake

A rear engine hard tail dragster. Its not mine. I'm going to be tuning it. I've used other tuning software before just not FAST XFI ... I've gotten a few awnser's now but not as many as I'd expected. Sounds like I won't be able to use C.O.P. if I want to take advantage of a lot of XFI's functions. I may end up going with MOTEC instead. We shall see.