Hey folks,
Working through my first engine build, 331 stroker. I’m at the pushrod measuring/ordering stage and I’m a little confused. I’ve watched some videos and tried to measure for length properly. I’m using Trickflow 1.6 RR’s, SVE 185 aluminum heads and FMS hydraulic roller lifters. I put the rocker on, finger tightened to remove “slop”, then went another 1/2 turn tightened lash adjuster to “firm” with an allen (cam base circle). Spun the engine for two cycles and checked the marks on the valves. I tested using stock pushrods. Is this acceptable?
Working through my first engine build, 331 stroker. I’m at the pushrod measuring/ordering stage and I’m a little confused. I’ve watched some videos and tried to measure for length properly. I’m using Trickflow 1.6 RR’s, SVE 185 aluminum heads and FMS hydraulic roller lifters. I put the rocker on, finger tightened to remove “slop”, then went another 1/2 turn tightened lash adjuster to “firm” with an allen (cam base circle). Spun the engine for two cycles and checked the marks on the valves. I tested using stock pushrods. Is this acceptable?