Me and a buddy got ahold of a car a while back that has some fire damage to the engine....it seems pretty much just external, but we're wondering how serious it could be inside the motor?
Our guess is that at least the water pump can't be used, but other than that the engine itself is ok? The fire wasnt so bad (i dont think) that it could have warped the heads or anything because there are still wiring harness pieces that have the wire/sleeves still unburned, and the radiator hoses aren't completely destroyed. It surely wasnt hot enough to melt anything metal.
Anyways...we had a pretty crappy night working on it last night. The motor itself actually has some GT40 heads on it...which was our main objective. We were going to just swap the entire motor into his coupe and clean it up, but we were unsure about the possible problems it might have.....well we set out to pull the heads off and just swap'm into his car.......which is where the problem came into play.
His coupe is an '86. The guy he got it from swore that the motor was out of a '90.....so taking that into belief we set out into pulling of the heads....then i noticed the crappy little heart shaped combustion chambers on the heads...then looked down to see some nice crappy flat top pistons.....the motor is a bone stock '86 motor, which means of course we can't use the GT40 heads on it..
So right now we're puting the burned motor back together after cleaning it up some....replacing all the gaskets and the water pump. Could there be anything seriously wrong with the motor internally? When the car ran (before the fire) it was pretty damn healthy....the fire was a result of some stupid fuel line routing... The pistons looked ok and the block itself still has a very good looking cross hatch to the bores.....it seems to be a pretty sound motor aside from being really ugly and a bit crispy. Aside from a total rebuild...what should we look for before puting the motor in his car?
Our guess is that at least the water pump can't be used, but other than that the engine itself is ok? The fire wasnt so bad (i dont think) that it could have warped the heads or anything because there are still wiring harness pieces that have the wire/sleeves still unburned, and the radiator hoses aren't completely destroyed. It surely wasnt hot enough to melt anything metal.
Anyways...we had a pretty crappy night working on it last night. The motor itself actually has some GT40 heads on it...which was our main objective. We were going to just swap the entire motor into his coupe and clean it up, but we were unsure about the possible problems it might have.....well we set out to pull the heads off and just swap'm into his car.......which is where the problem came into play.
His coupe is an '86. The guy he got it from swore that the motor was out of a '90.....so taking that into belief we set out into pulling of the heads....then i noticed the crappy little heart shaped combustion chambers on the heads...then looked down to see some nice crappy flat top pistons.....the motor is a bone stock '86 motor, which means of course we can't use the GT40 heads on it..
So right now we're puting the burned motor back together after cleaning it up some....replacing all the gaskets and the water pump. Could there be anything seriously wrong with the motor internally? When the car ran (before the fire) it was pretty damn healthy....the fire was a result of some stupid fuel line routing... The pistons looked ok and the block itself still has a very good looking cross hatch to the bores.....it seems to be a pretty sound motor aside from being really ugly and a bit crispy. Aside from a total rebuild...what should we look for before puting the motor in his car?