Butterfinger Member Aug 11, 2006 74 1 8 Washington Sep 16, 2011 #1 Sep 16, 2011 #1 Wiring looks pretty straight forward to install a Flex-a-Lite fan. Where's the best place to tap into an ignition controlled power source?
Wiring looks pretty straight forward to install a Flex-a-Lite fan. Where's the best place to tap into an ignition controlled power source?
Mustang5L5 That is…until I whipped out my Bissell Mod Dude Feb 18, 2001 43,366 18,112 224 Massachusetts Sep 16, 2011 #2 Sep 16, 2011 #2 Low coolant sensor power wire...front drivers side taped into the headlight harness
Butterfinger Member Aug 11, 2006 74 1 8 Washington Sep 17, 2011 #3 Sep 17, 2011 #3 I guessing by the thinness of the wire not much current flows through.
4rdnut Member Dec 14, 2010 188 1 16 Sep 18, 2011 #4 Sep 18, 2011 #4 The flexalite electric fan has the 10 gauge battery and ground wire and the 14-16 gauge ignition turn on wire. The ignition turn on wire only needs to signal the controller to switch over to the 10 gauge battery wire which carries the full load.
The flexalite electric fan has the 10 gauge battery and ground wire and the 14-16 gauge ignition turn on wire. The ignition turn on wire only needs to signal the controller to switch over to the 10 gauge battery wire which carries the full load.
