Forced Induction

[Jaime Tucjer]

I have a 99 mustang GT 4.6 2V. Im thinking about going forced induction. My motor is stock so is there a complete kit available and which is best for a fair price.

 

[squeak93]

Procharger kits can be found cheap used. Get a good maf and injectors and bolt it on.

 

[Jaime Tucjer]

Procharger kits can be found cheap used. Get a good maf and injectors and bolt it on.

Is there a certain procharger that would be best for my application.

 

[squeak93]

For a stock motor a p1sc is just fine. You can do a D1 and have all the blower you'll ever want but your going to be limited by BOTH with the factory short block.

 

[ADRENLN]

The answer is no. You can get a blower kit with an intercooler but like stated above your going to need assisting parts. Might need upgraded fuel system parts aside from injectors and a dyno tune.

 

[Jaime Tucjer]

What is a fair price for a used procharger kit.

 

[squeak93]

$1500-3000 depending on what all it comes with.

 

[Rdls19]

Be careful on the 2v mustangs. I put a kenne bell on mine and nothing but problems ever since. Blew the stock block for starters. It's a big money pit when you put blowers on just a fyi....

 

[Jaime Tucjer]

Be careful on the 2v mustangs. I put a kenne bell on mine and nothing but problems ever since. Blew the stock block for starters. It's a big money pit when you put blowers on just a fyi....

What's your thoughts on nitrous

 

[Rdls19]

I have never used it. I love blowers you just need deep pockets and patience with mod motors. old school push rods are much better.

 

[Neuron]

What's your thoughts on nitrous

Great for the strip with it tuned in correctly, not so much on the street. Great for the budget compared to supercharging and one of the easiest ways to blow up an engine.

 

[98snakehorse]

Wow, some of the info on here is trash. You can pick up a used vortech kit all day for around $1500 to $2000. I paid $1700 for a V3si vortech kit. Supporting mods shouldn' break the bank either. Around $100 for a walbro 255 pump. $150 for injectors and $50 for a lighting maf.

Then you need tuning software and a tune (Around $1000). You can make 380whp to 400whp very reliably as a daily driver no problem.

Around $3000 ou the door.

 

[Dark04GT]

I bought a new vortech v3 si tuner kit for about $3k. Around $200 for a walbro 290lph pump. $250 for injectors. Already had a SCT tuner. I could have finished there but I bought a three row intercooler, aluminum piping, and a SCT MAF. Right over $4k for all new stuff not including the cost of the dyno tune.

I’ve daily driven mine for several years with just routine maintenance.

 

[Rdls19]

Wow what year mustangs are you guys taking and and are they 2v . Kenne bell is much more expensive. Intercooler tranny cooler shift kit. It's all needed or say bye bye to your stock 4R70w trany and or block

 

[98snakehorse]

I have a 98. It' a stock 2v....my car made just over 400rwhp. With a stock t45 5spd. All for under $3000.

And if your stock 2v short block is letting go in the 400hp range find yourself a new tuner....

 

[Rdls19]

My stock blew up got a MMR one. The auto trans is my weak point. Dyno at 425 after I beef up the tranny with cooler and shift kit

 

[Rdls19]

Transmission has a OD light flashing when I'm on the interstate. Any ideas???

 

[98snakehorse]

Transmission has a OD light flashing when I'm on the interstate. Any ideas???

They typically indicates there is something wrong with the trans. You should be able to pull codes from an OBII reader. I know that works for the trucks.

 

[98snakehorse]

OP here is my car when it had the basic blower kit on. Made 400hp through a stock t45. Very basic setup and so very worth it.

 

[Jaime Tucjer]

I'm thinking supercharger is the best way to go.