Location: Kenmore, WA Price: $3,000 OBO
Hi everyone,
I am selling my Ford Racing 302 crate engine with clutch, intake manifold, and fuel rails, injectors, pressure regulator. This engine has never been turned over, it has just sat in my project car for the past 15 years, and now I am getting rid of the car. The engine is being pulled out of the car tomorrow and will sit on my garage floor until it is gone.
I have all the receipts, but JEGS apparently didn't list the manufacturer or each of the components back then:
The crankshaft, rods, and pistons were all replaced with forged versions. The pistons lowered the compression down to 11:1 if I recall correctly.
Edelbrock Performer RPM intake manifold (bored and had all the casting impurities cleaned up)
Bosch 42 lb/hr injectors (I believe I have the calibrated MAF for these as well)
GT-40Y aluminum heads
B303 camshaft
ARP studs everywhere
BBK aluminum valve covers
BBK 70mm throttle body
1.6 rockers
I can provide more pictures or information if requested. Thanks for looking!
Hi everyone,
I am selling my Ford Racing 302 crate engine with clutch, intake manifold, and fuel rails, injectors, pressure regulator. This engine has never been turned over, it has just sat in my project car for the past 15 years, and now I am getting rid of the car. The engine is being pulled out of the car tomorrow and will sit on my garage floor until it is gone.
I have all the receipts, but JEGS apparently didn't list the manufacturer or each of the components back then:
The crankshaft, rods, and pistons were all replaced with forged versions. The pistons lowered the compression down to 11:1 if I recall correctly.
Edelbrock Performer RPM intake manifold (bored and had all the casting impurities cleaned up)
Bosch 42 lb/hr injectors (I believe I have the calibrated MAF for these as well)
GT-40Y aluminum heads
B303 camshaft
ARP studs everywhere
BBK aluminum valve covers
BBK 70mm throttle body
1.6 rockers
I can provide more pictures or information if requested. Thanks for looking!
