I also go over the alternator last. By doing this, the belt can be routed around the tensioner pulley beforehand so you dont have interferance issues with the breaker bar. You are using a breaker, and not running out of room to move the tensioner pulley, right?biglg said:Ok,
I think I have this almost done, just waiting on my ANL fuse holder to get here in the mail. One last thing I need to do is put the belt back on. THis is the first time I have taken it off my car. What is the easiest way to get it back on? I was trying to put it over the alt pulley last. I messed with it for a few minutes and damn, I couldnt get it. Then the wife was yelling telling me to hurry up to go out to eat. I honestly dont think I can get the dam belt back on the way I was trying to do it. Can somone tell me exactly how to do it, what pully to pull it on last? I had to be trying something wrong, because i was 1/2-1 inch off, at least. Thanks guys.
Like I said, I dont think it matters at all really. I've noticed that OEM circuit protection is often towards the battery or power distribution side of things (towards the battery, in your situation). FWIW, the fuse on my 88 is next to the ignition coil (real close to the battery side of things). Kinda proves that IMHO it doesnt matter too much, esp with the nature of how these ANL fuses burn.biglg said:I never really thought of it that way, as the alternator as the powr source. I sure thought that I should have the fuse holder closer to the battery. I guess I will put it closer to the alternator if that is the best location. Thanks again.