Has anybody installed upper torque box re enforcements without dropping the rear end?? Was contemplating doing one side at a time, removing upper control arm installing the re-enforcement, bolting it back up, then switching sides. Is it worth as far as saving time and labor intensity???
I am thinking about reinforcing the rear axle torque boxes when I get subframe connectors welded in. (I finally found the connectors again after moving!) MM has front sway bar reinforcements, but I am not finding theIt battle or torque box kit. There are a lot of knockoffs or odd brands on eBay...
Has anybody installed upper torque box re enforcements without dropping the rear end?? Was contemplating doing one side at a time, removing upper control arm installing the re-enforcement, bolting it back up, then switching sides. Is it worth as far as saving time and labor intensity???
A while ago I watched a few videos on doing this, and I’m pretty sure the rear ends were still in. Search the yootoob and you’ll find a few good tutorials.