Roush Front Facia Number Installation Template

[BlackSaleen]

I am going to have my front Facia repainted. I ordered my numbers
from Saleen and just received them. I plan to take a picture of the front bumper before its repainted to make sure the new numbers get installed correctly. Would anyone here know if Saleen has a installation template with all the measurements for the correct installation? Its seems they would. Would they supply it if i asked?

BlackSaleen
2000 SC281 #0388

 

[marcus95]

The foxbody cars and the sn95 94-98's are easy. There is no template for the 99-04 cars. If you took a picture you will be good. Just center the 3 numbers below the headlight as good as you can.

 

[BlackSaleen]

Thanks Marcus you and Robert have the most information on
these cars.

Barry

2000 Saleen SC281 #388

 

[mrvids]

Can someone post a photo of a number on a '97 front bumper or similar, or do they just go directly under the headlight? My car came without the bumper numbers, so do I get silver ones to match the side stripes or should I get white?

 

[SVT Saleen]

Generally on Fox & SN95 cars, the last digit of the s/n is aligned with the seam where the driver's side headlight lense transitions to the side marker lamp portion of the headlight assembly. For the vertical alignment, drop a line straight down from the bottom of the headlight lense & measure 1/2" towards the front of the bumper cover.
I just measured it on my '98 to be certain about the alignment.

 

[marcus95]

the bumper number lines up with the outside edge of the drivers side headlamp just like the fox cars.

 

[mrvids]

Should mine be white or silver numbers on the bumper to go with the silver side stripes?

 

[bill89saleen304]

Your numbers should be the same color as your stripes.




See Ya Bill

 

[Head Paneer]

B,

Your car is one of the cleanest there is. Why are you painting?

 

[SyberSaint]

I am going to have my front Facia repainted. I ordered my numbers
from Saleen and just received them. I plan to take a picture of the front bumper before its repainted to make sure the new numbers get installed correctly. Would anyone here know if Saleen has a installation template with all the measurements for the correct installation? Its seems they would. Would they supply it if i asked?

BlackSaleen
2000 SC281 #0388

I am having my Saleen body kit repainted. What I did to make sure the spacing between numbers was correct is to take a piece of paper and tape it to the bumper, over the numbers. I then took a pencil and by using the side of the lead, I shaded the numbers to leave the impression of the numbers on the paper. You can then use the shaded paper as a guide for the spacing, during the build-up.

Dale in San Antonio