Fuel cooler

1991vert

10 Year Member
Feb 27, 2004
1,103
7
69
Ludlow, MA
would the fuel cooler be plumbed into the feed or return line? most that I see have a -06AN inlet/outlet and seems like they'd be on the small side to be plumbed into the feed line. Does it matter if it's plumbed into the return? either way the fuel is going to get cooled.

the purpose for plumbing one in would be to cool my aeromotive pump without the use of a fuel controller, which controls the speed of the pump at various RPMS; ie: Aeromotive fuel controller.

thanks!
 
so do i want the fuel cooler between the tank and the pump?:scratch: wouldn't make much sense with a gravity fed pump.

my thought was that it would continuously cycle through the cooler and the fuel in the tank would eventually end up at a cooler temp.? i just dont want my fuel pump to overheat
 
Well I would want the fuel cooler after the pump and before the regulator! If you cool the return line or the whole tank its just going to heat up while its going through the pump. The pump will cool more efficiently if you are only cooling the volume of fuel in the lines after the pump. Trying to cool all the fuel in the tank seems crazy.
 
lol well i was thinking about cooling the pump so that's why i thought that.

so between the pump and the y-block is where i want it.

i've heard of people putting a trans cooler w/ fan in the return line and cooling it. i guess it couldn't hurt to do both?
 
You are probably right. I didnt really think of having to cool the pump?? You are running a sumped tank with an external fuel pump IIRC? I think perhaps you should contact aeromotive and ask them if there is a need to keep the pump/fuel cool. I dont know enough about those setups to give you a good answer for the pump temps.