Passenger side, under the door, this piece of plastic on my car is showing the push pins, and is somewhat loose, but no danger of it falling off.
There's a screw inside the rear wheel well holding the end, and also quite a few push pins holding the assembly on underneath the car. All of those are good.
I tried pushing the trim back on, in fact braced myself against a wall, and with my feet pushed it back flush against the car, but as soon as I relieve the pressure, it pops back out. I have about a 1/4" gap that I can see maybe 5 or 6 of the pins through.
Any suggestions?
There's a screw inside the rear wheel well holding the end, and also quite a few push pins holding the assembly on underneath the car. All of those are good.
I tried pushing the trim back on, in fact braced myself against a wall, and with my feet pushed it back flush against the car, but as soon as I relieve the pressure, it pops back out. I have about a 1/4" gap that I can see maybe 5 or 6 of the pins through.
Any suggestions?