I am in the process of swapping out a GT-40 lower intake for an explorer intake. I noticed that the explorer lower had 2 bolt-holes in it that the GT40 lower did not have, so I simply used brass fitting to cover them...is that okay?
My main problem is that the GT40 upper and lower have an exhaust port running through the middle where the two mount onto eachother, but the explorer intake does not have it. If I install the GT40 upper with the exhaust port onto the Explorer intake without the exhaust port, will this cause a problem? I was told that it may affect the smog, but I am not concerned about that...I just want it to run right.
Please let me know if I can proceed with this swap...thanks atriot:
Here is the bottom of the upper manifold. Notice the small 9th hole in the center where it mounts:
Here is the GT40 lower...notice the small 9th hole in the center on the mounting surface:
Now here is the Explorer lower...NO small 9th hole in the center of the mounting surface:
My main problem is that the GT40 upper and lower have an exhaust port running through the middle where the two mount onto eachother, but the explorer intake does not have it. If I install the GT40 upper with the exhaust port onto the Explorer intake without the exhaust port, will this cause a problem? I was told that it may affect the smog, but I am not concerned about that...I just want it to run right.
Please let me know if I can proceed with this swap...thanks
Here is the bottom of the upper manifold. Notice the small 9th hole in the center where it mounts:
Here is the GT40 lower...notice the small 9th hole in the center on the mounting surface:
Now here is the Explorer lower...NO small 9th hole in the center of the mounting surface: