H Pipe Bracket Fab...help

J

ja1919

Member

Jul 26, 2004

91

0

7

May 25, 2005

#1

• May 25, 2005

• #1

OK i got a factory h pipe with no hangers...i welded 1/2 in steel rod on the pipe..but does anyone have dimisions of the angle of the bend in the bracket..or the distance between the two pieces..ALSO how much distance should there be between the top of the h pipe and the bottom of the trans cross member support when the pipe is installed...mine looks soo low...ANY DIMISIONS FOR THE BRACKET WILL BE HELPFULL

ALSO DONT POST..."DUDE JUST BUY A NEW H PIPE, PROBLEM SLOVED" CUZ IM NOT

 

J

ja1919

Member

Jul 26, 2004

91

0

7

May 25, 2005

#2

• May 25, 2005

• #2

Anyone????????????

 

G

GT89Mustang

New Member

Mar 31, 2005

0

0

0

Monmouth County, NJ

May 25, 2005

#3

• May 25, 2005

• #3

I can go out and measure for you later, got one in the garage.

 

J

ja1919

Member

Jul 26, 2004

91

0

7

May 26, 2005

#4

• May 26, 2005

• #4

any measurements would be very helpful...thanks..then it will not take me as long to fit the h pipe correctly

 

J

ja1919

Member

Jul 26, 2004

91

0

7

May 29, 2005

#5

• May 29, 2005

• #5

Any Help

 

ALMOST STOCK

Founding Member

Sep 23, 2000

1,250

41

88

CA.

May 29, 2005

#6

• May 29, 2005

• #6

I no longer have my stock H-pipe setup, but I can give you some dimensions off of the X pipe setup I have that is in my car from which ever point you want if it will help you any?