Head/Intake porting question

tooshort_128

New Member
Feb 6, 2006
13
0
0
I recently got my hands on a set of TFS twisted wedge heads. They are ported both intake side and exhaust side. The intake was ported to a Fel-pro 1250 gasket. Now my question is this, the Fel-pro 1250 opening is 2" x 1.2" which matches the port on the head and on the Track Heat intake. Should I leave everything as it is or have the lower intake ported to a 1262 for greater port velocity?? Any input would be greatly appreciated.
 
I'm a new-b to this and wondered if it would increase velocity into the head. Another question.......I noticed most heads (tfs,afr) used fel-pro 1250 intake gaskets fresh out of the box. Do the gaskets match tfs twisted wedges right out of the box or are they a little bit bigger than the ports?? Just curious because I have never compared a 1250 gasket to a box stock head.
 
You do not want the intake runner to be bigger than the head runner opening - ever. Yes, some intakes are the 1250 size from the factory and some are not which matches the 1250 size runner many aftermarket heads come with in stock form - what really matters is how much air does the intake flow compared to the head. You want them to be close or have the intake flow somewhat more than the head.