HEADS & CAM GOING IN THIS WEEKEND !!!

[FEESER 94 COBRA]

It's finaly time to put all my parts on this weekend !!! Edelbrock RPM performer heads,F303 cam,bbk underdrive pulleys, 70mm t-body,255lph pump,energy susp. motor & tranny mounts,new lifters,timing chain,pushrods,compcam 1.7 rockers,MSD dig.box,dist. & coil.

questions:

1.what should i set my fuel press & timing @ since i will now be flowing more air?
N/A ??
NOS ??

2.I allready know my computer will not get along with my new cam so what should i buy a pms or go with some type of a laptop set up ?? WHAT IS A TWEECER????

3.I have 17/10 cobra r wheels what is the widest tire i can fit (nitto,bfg,mt) what are the 315 tires like??

4.Any guess on how fast it will run???

I will be adding a holley systemax intake in the neer futer

 

[Zero Signal]

Well the Tweecer is cheaper than the PMS unit, but I think becuase of it's nature, it' alittle tougher to use. It's kind of a raw, rudimentary system if you will, but it's the best IMO.

You will definitly need something to get that running with the cam right. The injector timing on the stock computer is almost wrong for the stock cam

 

[FEESER 94 COBRA]

So how much is a tweecer ?Can i see some pics. & could some one send me some info just so i know what i am getting into . Thanks [email protected]

 

[CivicEater]

I belive the Tweecer RT is around 450 and the PMS is closer to 1000.....

Info at tweecer.com

 

[Fast94Cobra]

that setup should scream. pms is definitely easier to use, but if you have the time to learn it and the technical savy the teecers seem to work really well. make sure to get it dynoed and post those badass numbers