• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-

Help Me Decide If I Should Change Cars

  • Thread starter Thread starter Badd GT
  • Start date Start date Aug 27, 2013
Prev
  • 1
  • 2
First Prev 2 of 2

Gearbanger 101

Straight Outta Locash
20+ Year Stangneter
Aug 10, 2002
9,457
1,377
234
Ontario, Canada
Sep 1, 2013
#21
  • Sep 1, 2013
  • #21
sneaky98gt said:
Spray above 3K RPM and you're good to go.

That's why I was spraying a dry shot. The torque from a 30 horsepower shot is awesome at 1500 rpm.
Click to expand...
True, but in your case, you're getting a double benefit. You're not only getting the extra N2O introduced into your oncoming airstream, but the cooling benefit of the chilled gas to keep ACT's down as well. You've better have a decent fuel system if you ever consider spraying a big shot with your blower. Yours is a prime candidate for a lean burn down otherwise.
 

sneaky98gt

10 Year Member
Apr 23, 2008
2,387
144
114
NC State University
Sep 1, 2013
#22
  • Sep 1, 2013
  • #22
Gearbanger 101 said:
True, but in your case, you're getting a double benefit. You're not only getting the extra N2O introduced into your oncoming airstream, but the cooling benefit of the chilled gas to keep ACT's down as well. You've better have a decent fuel system if you ever consider spraying a big shot with your blower. Yours is a prime candidate for a lean burn down otherwise.
Click to expand...

Haha. Very true. I shot it on the dyno once, and I'm too lazy to go find the graph and post, but it did go a little lean right when it hit, from a typically 11.8 to about 12.5. Not that bad, but it also wasn't a very big shot.

That setup is long gone, though. I had a few good track trips with it, and it worked quite well. A 30 hp jet picked up 5 mph and .4 seconds on most runs. The ET would have been better if it was tuned for it; the tune simply didn't have enough timing in it to make the torque needed for good 60's. Best it went was a 11.75 at 121 on a 1.83 60'. It cut a 1.74 one time, had a 330' that was .2 best than the 11.75 run, but had a hiccup just before the 1/8 when shifting to 3rd, and still only ran a 11.7. Probably would have been an 11.4 run. All from a 30 shot. I've since added gears, and ported/pullied the blower; therefore, the car should now have the low RPM torque needed to get it moving a little better without the nitrous.

Also, the nitrous had exactly 0 effect on the ACTs. Couldn't tell one thing different about it at all. I don't know how a bigger shot would affect non-intercooled blowers (like mine), but I also know people running a big shot on 03/04 Cobras with Eaton, and it doesn't make a difference on those either. Sure, the nitrous is cold, but the low volume relative to incoming air and low specific heat capacity results in it not actually cooling the air much at all. OTOH, I'm spraying a LOT of water/meth relative to the air coming in (about 1 fluid ounce every 2 seconds), and it absorbs a ton of heat because of the way the methanol and water are bonded together.
 
B

Badd GT

Founding Member
Mar 7, 2002
418
0
17
Kansas City
Sep 2, 2013
#23
  • Sep 2, 2013
  • #23
I have the Trickflow intake so can't do plate and spraying 125hp or less above 3k Rpms shouldn't puddle
I have considered a 25-40 dry shot thru meter for yrs
That is why I have 30lb injectors instead of 24lb
As far as lean hit I have heard A/F ratio gets leaner a little bit even on wet kits so I assumed it was that time from when the fuel for the nozzle sucks from the rail for car to increase voltage to pump and pump to increase and get it back up to the rails at the fixed fuel pressure
 
Prev
  • 1
  • 2
First Prev 2 of 2
You must log in or register to reply here.

Similar threads

R
What's it Worth? 1997 Cobra, a ton of mods and restoration
  • riored97snake
  • Jun 18, 2026
  • What is it Worth?!?!?
Replies
2
Views
179
What is it Worth?!?!? Jun 21, 2026
riored97snake
R
S
5.0 Rebuild
  • smittys7up
  • Nov 29, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
579
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Dec 20, 2025
Noobz347
R
94’ SN95 - Intermittent lope & bogging at moderate rpm
  • Red5.0ho
  • Nov 2, 2025
  • 1994 - 1995 Specific Tech
Replies
5
Views
465
1994 - 1995 Specific Tech Nov 3, 2025
General karthief
Place to Avoid: Jamison Auto Group in Gulfport, MS
  • D Durden
  • Oct 20, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • 2 3
Replies
46
Views
3K
1965 - 1973 Classic Mustangs -General/Talk- Jul 16, 2026
Noobz347
S
65 Coupe I6 Auto to 302 EFI 5 Speed Swap
  • Scuderia
  • Feb 3, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
14
Views
1K
1965 - 1973 Classic Mustangs -General/Talk- Sep 9, 2025
Noobz347
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?