HELP PLEASE!!

jdgt281

New Member
May 30, 2005
20
0
0
Florence, Alabama
Hey guys, i have been havin a noise problem from my 89 coupe since i bought it.. Well i pulled rocker arms off and the pushrods out and soon noticed a problem one pushrod was stock length and all the others were longer!! WTF. Also all the long ones were slightly bent and the stock one was fine. The motor is a 306 with World product Roush 200 heads, Lunati Cam, Erson 1.6 roller rockers. Can anyone tell me what length pushrods i need for this so i dont have to buy a checker. I figure someone has had this problem. The heads do have guideplates also. Thanks in advance.
 
If you have bent rods you might of had a little valve on piston action. Bring your #1 cylinder up to tdc and use your 6.250 pushrod as your checker. Place it in the intake valve side first color your valve stem with dark sharpy marker put on you rocker and set your valves as if you would any other time. Rotate motor over by hand. Remove your rocker and check the line on your valve stem it should ride in the center of the stem. If so try exhaust side and if you get the same result buy a stock set of pushrods and have at it.
 
since you say you have bent pushrods, best bet is it to do a leak down test to make sure you don't have any bent valves. we can't really tell you the right length pushrods to buy, only guesstimate. to find the correct length you will have to buy a rod checker.